Yes, actually (i think by mistake) I used the cement for this step. And the end cap ring popped off at some point ( Luckily while preparing the dive :) ) and i reglued it with super glue.
Is it also possible to update the ROV through the dashboard ( i think there is an option that sounds like that)
If i built a new rov, is it possible to measure precisely the length and then directly solder the cables from the db 25 connector, which i have not cut yet?
I think it is just to prevent the epoxy from flowing elsewhere
If I am not mistaken the 2.8 ROV does only have one syringe, correct?
Successfully completed Converting a 2.6/2.7 to 2.8.
@ 02:23:01 AM
Wrote comment "Guide 4 - Wire Routing".
@ 03:58:11 AM
Successfully completed OpenROV Operators Manual.
@ 09:43:05 AM
Wrote comment "Update Software Image From SD Card".
@ 06:52:11 AM
Successfully completed Update Software Image From SD Card.
@ 06:51:05 AM
Successfully completed IMU/Depth Module 2.0 for all OpenROVs (Production started July 2015).
@ 01:22:19 PM
Wrote comment "IMU/Depth Module 2.0 for all OpenROVs (Production started July 2015)".
@ 04:38:50 AM
@ 01:03:39 PM
Successfully completed Guide 3 - Electronics.
@ 07:17:08 AM
Successfully completed Guide 2 - Electronics Tube Endcaps.
@ 07:16:17 AM
Wrote comment "Guide 2 - Electronics Tube Endcaps".
@ 07:16:08 AM
Wrote comment "OpenROV Operators Manual".
@ 03:19:29 AM
Successfully completed Guide 1 - Acrylic Cementing.
@ 02:49:10 AM
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.