Prep the slip ring by coiling the 4 unused wires. Use a zip tie to hold them in place.
I went a step further and applied hot glue to the wire ends to water proof them and around the seam of of the slip ring for the same reason.
Solder the tether wires to the slip ring wires. I used the hot glue and water proof heat shrink on this joint.
Affix the slip ring to the mount using the lock nuts
At this point I would recommend winding the tether on the reel (I had done this previously but then you have to take things apart again). Place the reel back into the frame and reattach the handle.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.