Measure the inside diameter of the reel opening. Make sure you are measuring the side that the hole you drilled in the previous step is on.
Cut a piece of material to those dimensions. I had some thing acrylic lying around that I glued together but pretty much anything will work.
Cut a hole in the center that matches the thick part of the slip ring behind the flange.
Place the slip ring in the hole and mark the location of the 3 holes.
Drill out the three holes
Sand the material around the three holes to allow for a better epoxy bond
Tape the threads of your bolts so they don't get epoxy on them (remove the tape once everything dries)
Epoxy the bolts to your material
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.