Bend the leads of the polyfuse perpendicular to the fuse in opposite directions.
Place the polyfuse into the gap in the acrylic piece. The fuse leads should fit easily through the holes on each side of the adapter.
Place the other button terminal on the acrylic with the lead of the polyfuse going through the small hole.
Make sure that the metal battery terminals aren't off center enough to keep the adapter from fitting in the battery tubes. Test fit them if you are unsure.
Use superglue to hold this button terminal in place.
Ensure that the polyfuse leads are not touching each other when packed into the gap!
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.