Solder motor wires to the 3 green wires. The order of the three wires from the motor to the 3 green wires does not matter.
Slide the heat shrink over the solder joints and use a heat gun on all 3 joints. Make sure it is entirely heated on all sides to ensure the adhesive is melted inside the heat shrink and encapsulating the joint.
If you had to make the modifications to your motor insulation make sure that the heatshrink completely covers all the bare wire. The enameled wire will be protected against seawater, but the bare wire or the soldered area should be completely covered by completely melted heatshrink.
When soldering it is recommended that you wear safety glasses and have air circulation in the room you are working.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.