Skip to main content
/

Site Navigation

Your Account

Choose Language

Help

Step Type:

Drag to rearrange

Place an 8mm nylon M3 screw through the hole on the electronics board.

Thread the standoff onto the screw.

Remove your BeagleBone Black (BBB) from the box and attach the other end of the Ethernet jumper to your BBB. Keep the USB wire that comes in the box. You will need this to operate the ROV.

Press the BeagleBone Black onto the extended header set on the Controller Board as shown. Make sure the header pins on each board are aligned with each-other properly!

Secure the BeagleBone Black to the nylon standoff using an additional nylon M3 screw.