I know this is the hardest part.
While you are waiting for the parts to arrive it might be a good time to prepare the cable spool.
Drill a hole (3mm or so) through the marked spot. Be aware not to drill through the inner part of the spool. This hole will be used to put the end of the tether that goes to the topside adapter through it.
When you drilled the hole through one side of the spool put around 10cm of tether trough it (I had to extend my wire a bit since i did not put enough of tether through it. see picture 2).
Attach the topside adapter with double sided tape or some other non permanent adhesive to the yellow marked place. Make sure that the LEDs are visible.
Attach the tether to the topside adapter
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.