We need 5V power for the Topside Adapter. The best place to get them on this board is on the underside.
Before you solder, check which pins are Ground and +5V
According to USB standards, Ground should be Black and +5V should be Red (the wires with these colors are on the other side)
Use some small gauge wires and solder them onto the pins carefully
Make sure you don't short two pins.
There are normally 4 wires + 1 for the shielding
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.