There are three different sizes of screws in the kit. Pay close attention to the screws used in a particular step.
Use new screws in all cases, except for the horizontal motor covers (phillips head screws).
Over-tightening screws can cause serious damage to your Trident. Here's how to get it just right:
Use the L-wrenches provided. They were chosen specifically to avoid over-torquing.
Tighten a screw until you first begin to feel resistance, like it's almost tight. Then, turn an additional quarter-turn (90º). Do not exceed a quarter-turn.
Test connections by trying to gently wiggle the part. It should not feel loose at all. This will be referred to as the "wiggle test" :)
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.