Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 78 —

Step Type:

Drag to rearrange

Solder wires onto the remaining three pins (one close to the Ethernet jack on the 3-pin header, and two on a separate header toward the back of the board)

Solder the two leads from the 2-pin header respectively to the "+5v" line coming from the USB REG and the left over pin (GND) on the 3-pin header. It does not matter which wire from the 2-pin header attaches to the 5v supply or the ground.

Pull the two sets of joined wires through the each hole on the back of the topside adapter using pliers.