Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 72 —

Step Type:

Drag to rearrange

You can now mount the internal components you've completed to the shell of the ROV. This is best done with the ROV up-side-down.

Rout the wire harness through the opening in the main bulkhead on the starboard side of the ROV.

Place the internal structure into the shell and allow the tabs of the internal structure to click into place.

Move the two battery tubes so that they are resting forward of the bulkhead. This will position them in the correct place once the threaded rods are put in.

Add one non-locking M5 nut to each end of each threaded rod, about 1cm in from each end.