Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 67 —

Step Type:

Drag to rearrange

To keep the USB cable for the webcam out of the way, we'll wrap it around the main platform of the E-Chassis. Because the Electronics Tube will have to fit over the entire assembly, it's important that the wraps of cable are side-by-side and do not stack on top of each-other.

Depending on where the end of the doubled-up cable ends up (that seems to vary every time we build an E-Chassis) you can use the velcro strip that came with it, some tape, or a small zip tie to hold it in place.

The resulting bundle should lay flat against the E-Chassis platform, but be pushed to the side enough so that when the camera platform is pointing all the way up or down, the camera doesn't collide with the cable.