Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 60 —

Step Type:

Drag to rearrange

There are five connecting pins between the two boards- three in the front and two in the back. Clip these pins as close as you can to the power regulation board (the one without the Ethernet jack) to separate the boards.

Be careful to clip the pins on the side of the power regulation board, NOT on the side of the communication board. You'll need pins coming out of the communication board in order to plug into the Controller Board later on.

If you can't get cutters into the board as shown in the picture, then you can unsolder the 3 pins on the power regulator side, as we will be discarding the power regulator board