Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 42 —

Step Type:

Drag to rearrange

The wire harness can now be inserted into the port endcap. Insert the wire harness from the flange end inward as shown.

Pull the wire harness through the endcap until the marks on the wires made earlier are flush with the inner plate of the endcap.

To verify that the wire markings are in the right place (so that the harness will not be too long or too short), position the endcap in its cradle and check that the mesh-covered part is slightly slack.

If the harness is not the right tightness, it can be adjusted. If this is done, you should make a new mark on the wire to indicate the appropriate place it should pass the inner face of the endcap.