Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 33 —

Step Type:

Drag to rearrange

Cut three 3cm-long lengths of black 3M EPS-300 (adhesive-lined) shrink tubing

Slide one of the 3cm lengths of adhesive shrink tubing down each of the newly attached leadwires. Make sure the shrink tubing is slid all the way down the leadwire and over the solder joint until it bottoms out at the stem of the magnet wire from the motor.

Shrink the tubing with a heat gun until the inner lining oozes out its ends.

3M EPS300 seems to need a little more time and heat to fully shrink.