Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 23 —

Step Type:

Drag to rearrange

Next, we'll glue the disks for the forward endcap. This is where the motor bell comes in- we're going to use it as a centering pin

Slide the larger forward endcap disk (28mm diameter) over the motor bell. Then slide the smaller one (24mm diameter) on. It will be a very tight fit. Cement them together.

Take another large endcap and sandwich the smaller one. Cement it in place.

Attach and cement the outer forward battery endcap disk.

Visually inspect that the shaft going through the disks is perpendicular to them- although the fit is tight, it is still possible for the shaft to end up somewhat angulated

Sand a corner of the button terminal (any corner of the button terminal - on button side)