Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 22 —

Step Type:

Drag to rearrange

Align and glue outer and middle disks of aft endcap. It’s important that it lines up correctly - the nub of the middle disk accenting the hole on the outer disk.

Measure out 25cm of wire length passing through the spring terminal endcap. (Good idea to make a reference mark on the wire near the base of the terminal.

Slip the middle and outer disks over the longer length of wire. Both wires through the middle hole.

Double check that the wire is 25cm (once the disks are cemented together, it’s very hard to pull the wire in or out).

Make sure the inner, middle, and outer disks are concentric (visual). Then glue them together.