Once your ROV is fully assembled, you may need to change the buoyancy and ballast on it to make sure it is neutrally buoyant in water.
This camera runs warmer than the previous camera. When operating we recommend letting the camera warm up the air in the tube before completely sealing it, otherwise there is pressure that can cause the endcaps to pop off.
To do this, turn your system on, remove the vent syringe in one of the endcaps and let your ROV sit for 30 minutes. This will warm the air and letting the built up pressure escape.
Make sure you insert the syringe before your dive!
Congratulations on finishing the build, if you run into any issues during operation please email us at firstname.lastname@example.org
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.