New holes need to be drilled to cable tie the new wiring to the Frame. I used a 3mm drill bit but as i had small cables ties
Holes need to be drilled two above and below the connector for the case to attach. On the 2.6 its a kind of rounded piece with pegs on.
The holes should be the same distance and the width of the cable so place the cable up to the acrylic and mark with a marker pen
For the Middle section you should be able to find existing holes in the frame that allow cable ties (shown in 2nd and 3rd picture)
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.