The new configuration of the 2.8 system requires the vertical DB25 to be horizontal.
So in order to do this the old one must be removed this can be one of two ways
1. Take a hacksaw and carefully cut the whole thing off leaving only the pins of the DB25. Which can then be unsoldered.
2. Try to unsolder the vertical DB25 connector by unsoldering each connection with a solder sucker and then take the whole thing off. This takes a lot longer and is generally harder than the first method but potentially a lot better for the electronics board.
Solder on the new horizontal DB25 connector
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.