Now that the epoxy in your endcap has had a little time to cure, we can get ready to add the DB-25 connector to the end of the wiring harness that passes through the endcap.
Start by removing the tape that was used to hold the bundle together
Next, measure a distance of 17cm from the inside surface of the endcap, and cut one of the wires from the bundle at that length. Measure twice, cut once- you don't want the harness to be too long or too short by more then about 1cm!
Use the one wire that you've cut as a guide to cut all the remaining wires in the bundle to the same length
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.