Now we're going to route the yellow mesh sleeve material over the main wire harness. The sleeve material expands when it is compressed much like how a finger trap works.
Start by wrapping tape around the ends of all the wires in the main harness as shown. The purpose of this is to prevent the sleeve material from getting snagged as it is placed over the harness.
If only a few individual wires are left sticking out of the tape, and their labels are further down the wire, those ends can be snipped off.
Push the sleeve over the main wiring harness and slide it all the way down until its end goes past the bulkhead of the internal structure.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.