Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 14 —

Step Type:

Drag to rearrange

Now we're going to start cementing the endcap disks together.

The first two pieces you'll cement together are the 3mm-thick disk and the 6mm-thick disk with a smaller hole in the center.

The 3mm-thick piece will end up being the inner-most disk of the endcap. Place the syringe section in the centering holes of the two disks so that the plunger stop-end of the syringe section is facing the inner disk.

You may also notice small notches extending from one side of the inner disk (a result of the laser-cutting process). Ideally these notches should face inward (away from the 6mm disk) as they may make it harder for the o-ring to seal properly.