Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 8 —

Step Type:

Drag to rearrange

SAME PROCEDURE FROM 2.6 BUILD GUIDE

Cut quantity 9 pieces of waterproof heat shrink tubing, length should be 2-3cm.

Apply a small amount of hot glue to the joint as shown.

With the hot glue still warm, slide the heat shrink tubing over the joint.

Make sure the pieces of shrink tubing are slid all the way up the wires so that each solder joint is completely covered.

Heat the tubing with a heat gun until the gel lining and hot glue inside oozes out from the tubing on both sides.