Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #1

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Step 1 - Wire Routing + Soldering
[title] Step 1 - Wire Routing + Soldering
[* black] First set up wires accordingly to the IMU, refer to image 1. Red/gray to 3.3v, black/gray to GND, green/gray to SCL, and white/gray to SDA
[* black] Have the wires go through the top of the board and solder on the bottom side.
[* black] Clip the excess wires.
[* icon_caution] Wear safety glasses when clipping excess wires.