Changes to Step #1
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [title] Step 1 - Wire Routing + |
| [title] Step 1 - Wire Routing + |
| [* black] First set up wires accordingly to the IMU, refer to image 1. Red/gray to 3.3v, black/gray to GND, green/gray to SCL, and white/gray to SDA |
| [* black] Have the wires go through the top of the board and solder on the bottom side. |
| [* black] Clip the excess wires. |
| [* icon_caution] Wear safety glasses when clipping excess wires. |