Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #11

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Deleted
Added
Unchanged

Step Lines

[title] Apply Image to BBB
[* black] Remove the BBB from your ROV. Insert the microSD card into your BBB.
[* black] Remove the BBB from your ROV. Insert the microSD card into your BBB.
[* black] Plug the USB wire into the BBB to power it up.
[* red] The USER LEDS will blink to show that the image is being applied to the BBB memory.
[* black] The process takes about 15 minutes to complete.
[* orange] Once the flashing process is complete the 4 USER LEDS will stop flashing and be on. If the lights do not all go solid, unplug the USB cable and plug it back in and wait 15 minutes again.
[* black] When this is complete, remove the USB cable from the BBB to power it off and remove the microSD card.
[* icon_note] If you removed yourblack] Attach the BBB fromto your controller board, you can now reattach itboard.
[* icon_note] If you removed yourblack] Attach the BBB fromto your controller board, you can now reattach itboard.
[* black] '''You will need to also update the firmware on the Ardunio. Please read all the way to the end of this guide.'''