Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #23

Edit by Thomas Moye

Edit approved by Thomas Moye

Before
After
Unchanged

Step Lines

[title] Laser Calibration-(cont)
[* black] Once the laser is placed in the hole, you will see that is has some play. Apply minimal super glue to the inside of the laser hole. Apply a small amount of super glue to the opposite side of the laser and place in the hole.
[* black] The trick here is to align the laser with the bottom X on the calibration sheet while the super glue is drying (about 1 minute). When you let go of the laser it should stay aligned with the X. Let this dry and repeat for the top laser.
[* black] When finished you should be able to walk away from the calibration station and the lasers should dry in the e-chassis as shown in fig 3. When completely cured (see instructions for super glue), your lasers are calibrated.