Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #23

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)


Step Lines

[* black] Once the laser is placed in the hole, you will see that is has some play. Apply minimal super glue to the inside of the laser hole. Apply a small amount of super glue to the opposite side of the laser and place in the hole.
[* black] The trick here is to align the laser with the bottom X on the calibration sheet while the super glue is drying (about 1 minute). When you let go of the laser it should stay aligned with the X. Let this dry and repeat for the top laser.
[* red] When gluing the lasers make sure that thy do not protrude past the acrylic or they will rub on the inside of the electronics tube.
[* icon_caution] Careful to to glue your finger to the laser. Wear gloves and safety glasses when using glues and solvents.
[* black] When finished the lasers should dry in the electronics chassis as shown in fig 3. When completely cured (see instructions for super glue), your lasers are calibrated.

Image 1

Old Version

New Version