Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Tighten the lock nuts using the wrenches turning in opposite directions. They should only be tightened so the rod is flush with the outside of the locknut.
[* black] Do this for both rods. OnceOnce you have the structure secure and how you like it. Tighten the inside jam nuts with your fingers to secure the shell.
[* black] Do this for both rods. OnceOnce you have the structure secure and how you like it. Tighten the inside jam nuts with your fingers to secure the shell.
[* black] When complete your structure should fit together well and look like fig 3.
[* black] Screw the inside nut so that the shell is snug between the lock nut and inside nut.
[* icon_note] Both sides of the shell should fit snugly against the motor chassis. You may need to remove any excess plastic in the shell notches to ensure a good fit. The pieces should fit together without much force.