Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Propellors
[* black] Shave off any excess plastic from the props.
[* black] Take all the hardware (nuts, washers, and lock nuts) from the motor shaft. Save the lock nut and screw down as shown onto the motor shaft. The lock nut will be tightened upward to lock the prop in place.
[* black] Screw the appropriate propellor (RH,LH,Vertical) onto the shaft, and tighten the lock nut. Thisnut counter to the propellor. '''This should be nice and tight so it does not come unscrewed during operationoperation.'''
[* icon_note] ''Loctite'' adhesive can be used for a more permanent fit if desired
.
[* black] Take all the hardware (nuts, washers, and lock nuts) from the motor shaft. Save the lock nut and screw down as shown onto the motor shaft. The lock nut will be tightened upward to lock the prop in place.
[* black] Screw the appropriate propellor (RH,LH,Vertical) onto the shaft, and tighten the lock nut. Thisnut counter to the propellor. '''This should be nice and tight so it does not come unscrewed during operationoperation.'''
[* icon_note] ''Loctite'' adhesive can be used for a more permanent fit if desired
.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added