Changes to Step #17
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [title] |
| [title] |
| [* black] Starting with the starboard side, measure out where you should cut the green wires to solder the motor on. |
| [* icon_note] You want a length/location that you will be able to tuck the wires back into the sleeve '''AND''' avoid getting caught in the propeller '''AND''' not rub against the motor bell when it |
| [* icon_note] You want a length/location that you will be able to tuck the wires back into the sleeve '''AND''' avoid getting caught in the propeller '''AND''' not rub against the motor bell when it |
| [* black] Cut the wires at the desired location and strip the ends. |
| [* black] Slide a strip of heat shrink on each leg of the motor. '''REMEMBER TO |
| [* black] Slide a strip of heat shrink on each leg of the motor. '''REMEMBER TO |