Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #17

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Starting with the port side, measure out where you should cut the red wires to solder the motor on.
[* icon_note] You want a length/location that you able to tuck the wires back into the sleeve '''AND''' avoid getting caught in the propeller '''AND''' not rub against the motor bell when it runs
[* black] Cut the wires at the desired location.
[* black] Once cut, strip the ends and slide a strip of heat shrink on each one.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added