Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #17

Edit by JR Wong

Edit approved by JR Wong

Before
After
Unchanged

Step Lines

[* black] Starting with the portstarboard side, measure out where you should cut the red wires to solder the motor on.
[* black] Starting with the portstarboard side, measure out where you should cut the red wires to solder the motor on.
[* icon_note] You want a length/location that you able to tuck the wires back into the sleeve '''AND''' avoid getting caught in the propeller '''AND''' not rub against the motor bell when it runs
[* black] Cut the wires at the desired location.
[* black] Once cut,
location and strip the ends and slideends.
[* black] Slide
a strip of heat shrink on each one.leg of the motor. '''REMEMBER TO USE THE CORRECT PROPELLER TO THE CORRECT SIDE'''
[* black] Cut the wires at the desired location.
[* black] Once cut,
location and strip the ends and slideends.
[* black] Slide
a strip of heat shrink on each one.leg of the motor. '''REMEMBER TO USE THE CORRECT PROPELLER TO THE CORRECT SIDE'''

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version