Changes to Step #3
Edit by Nils Jakobi —
Edit approved by Nils Jakobi
- Before
- After
- Unchanged
Step Lines
[title] Setting up the Nano Router |
[* black] Now that the Powerbank and the Nano router has arrived unpack everything. |
[* black] Connect the Nano Router to your PC or Laptop with the flat ethernet cable that came with it. |
[* black] The router will assign an IP adress to your pc (make sure that DHCP is enabled) |
[* black] Open up your preferred Browser and type in the IP of the Router (192.168.0.254) |
[* black] Make sure that the Working Mode is set to AP. If not change it to it. |
[* black] Next we need to change the Adress Type under Network -> LAN. Change it to Static IP and type in the following IP Adress: 192.168.254.2. Leave Subnet Mask to 255.255.255.0. If you didn't restart your Router until this point it is a good time to do this now. |
[* black] Once this has been done we need to access our Router through the new adress. So type in 192.168.254.2 in your browser to access it. |
[* black] Now it is time to give your WiFi network a name. Go to Wireless -> Wireless Settings and type in the SSID. I went with OpenROV for the time being. Everything else I left untouched. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added