Changes to Step #1
Edit by Eric Stackpole —
Edit approved by Eric Stackpole
- Before
- After
- Unchanged
Step Lines
[* black] You'll need the following materials: |
[* black] About 55cm (22") of 1/2" PVC pipe. I don't know what the metric equivalent is, but 1/2" PVC has an outside diameter of about 2.25 cm or 7/8" |
[* black] Two unthreaded tees and two unthreaded 90-degree elbows for 1/2" PVC pipe |
[* black] PVC cement |
[* black] Cut one piece of pipe 30 cm (12") long, and two pieces 11.5 cm (4.5") long. |
[* black] Sand the ends of the pipe pieces to remove any burrs. Check that the pieces fit into the tees and elbows. |
[* black] Using the PVC cement, assemble the pieces into the shape shown in the photographs. Allow to dry overnight. |