Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #25

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Attach vertical motor to motor cover
[* black] Screw in twoUse M3 6mm motor mount screws. Do not over-tighten screws.
[* black] Tighten the first screw about halfway, then start the other screw.
[* black] After both screws are in place and partially tightened, fully tighten them.
Turn screws until they begin to become tight. Then give an additional quarter turn (90º).
[* icon_caution] Do not over-tighten screws. Doing so can result in damage to your Trident that would require a return to OpenROV to repair.
[* black]
Do a wiggle test of the motor to make sure it is the vertical motor is securely mounted. Do this step for both horizontal motorsattached to the motor cover.
[* black] Screw in twoUse M3 6mm motor mount screws. Do not over-tighten screws.
[* black] Tighten the first screw about halfway, then start the other screw.
[* black] After both screws are in place and partially tightened, fully tighten them.
Turn screws until they begin to become tight. Then give an additional quarter turn (90º).
[* icon_caution] Do not over-tighten screws. Doing so can result in damage to your Trident that would require a return to OpenROV to repair.
[* black]
Do a wiggle test of the motor to make sure it is the vertical motor is securely mounted. Do this step for both horizontal motorsattached to the motor cover.