Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] A few notes about screws
[* icon_note] There are three different sizes of screws in the kit. Pay close attention to the screws used in a particular step.
[* icon_note] Use new screws in all cases, except for the horizontal motor covers (steps 6 and 31)phillips head screws).
[* icon_caution] ''' Over-tighteningOver-tightening screws can cause serious damage to your Trident. Here's how to get it just right:right:'''
[* icon_note] Use new screws in all cases, except for the horizontal motor covers (steps 6 and 31)phillips head screws).
[* icon_caution] ''' Over-tighteningOver-tightening screws can cause serious damage to your Trident. Here's how to get it just right:right:'''
[* red] Use the L-wrenches provided. They were chosen specifically to avoid over-torquing.
[* red] Tighten a screw until you first begin to feel resistance, like it's almost tight. Then, turn an additional quarter-turn (90ยบ). '''Do not exceed a quarter-turn.'''
[* icon_note] Test connections by trying to gently wiggle the part. It should not feel loose at all. This will be referred to as the "wiggle test" :)