Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Heed theA few notes about screws!screws
[title] Heed theA few notes about screws!screws
[* icon_note] There are three different sizes of screws in the kit. Pay close attention to the screws used in a particular step.
[* icon_note] Use new screws in all cases, except for the horizontal motor covers (steps 6 and ???31)
[* icon_caution] '''Apply just the right amount of torque to avoid over-tightening.''' Over-tightening screws can cause serious damage to your Trident. Here's how to get it just right:
[* red] Use the L-wrenches provided, even if they are less comfortable or convenientprovided. They were chosen specifically to avoid over-torquing.
[* red] Tighten a screw until you first begin to feel resistance, like it's almost tight. Then, turn an additional quarter-turn (90º). '''Do not exceed a quarter turnquarter-turn.'''
[* icon_note] Test connections by trying to gently wiggle the part. It should not feel loose at all. From this point forward, thisThis will be referred to as the "wiggle test" :)
[* icon_note] Use new screws in all cases, except for the horizontal motor covers (steps 6 and ???31)
[* icon_caution] '''Apply just the right amount of torque to avoid over-tightening.''' Over-tightening screws can cause serious damage to your Trident. Here's how to get it just right:
[* red] Use the L-wrenches provided, even if they are less comfortable or convenientprovided. They were chosen specifically to avoid over-torquing.
[* red] Tighten a screw until you first begin to feel resistance, like it's almost tight. Then, turn an additional quarter-turn (90º). '''Do not exceed a quarter turnquarter-turn.'''
[* icon_note] Test connections by trying to gently wiggle the part. It should not feel loose at all. From this point forward, thisThis will be referred to as the "wiggle test" :)