Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #21

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Install horizontal motor mount screws
[* black] Use two '''M3 10mm''' motor mount screws.
[* black] On one motor mount, tighten the first screw about halfway, then start the other screw for that mount.
[* black] After both screws are in place and partially tightened, fullyFully tighten them. Turnthe screws by turning until they begin to becomeget tight. Then give an additional quarter turn (90º).
[* black] After both screws are in place and partially tightened, fullyFully tighten them. Turnthe screws by turning until they begin to becomeget tight. Then give an additional quarter turn (90º).
[* icon_caution] Do not over-tighten screws. Doing so can result in damage to your Trident that would require a return to OpenROV to repair.
[* black] Do a wiggle test on the motor to make sure it is securely mounted.
[* black] Do this step for both horizontal motors.