Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #21

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Install horizontal motor mount screws
[* black] Screw inUse two M3 10mm'''M3 10mm''' motor mount screws.
[* icon_caution] '''Do not over-tighten screws'''black] On one motor mount, screw in the first screw about halfway, then start the other screw for that mount.
[* black] After both screws are in place and partially tightened, fully tighten them
. Turn screws until they begin to becomebecome tight. Then give an additional quarter turn (90º).
[* icon_caution] Do not over-tighten screws. Doing so can result in damage to your Trident that would require a return to OpenROV to repair.

[* black] Do a wiggle test ofon the motor to make sure it is securely mounted.
[* black] Screw inUse two M3 10mm'''M3 10mm''' motor mount screws.
[* icon_caution] '''Do not over-tighten screws'''black] On one motor mount, screw in the first screw about halfway, then start the other screw for that mount.
[* black] After both screws are in place and partially tightened, fully tighten them
. Turn screws until they begin to becomebecome tight. Then give an additional quarter turn (90º).
[* icon_caution] Do not over-tighten screws. Doing so can result in damage to your Trident that would require a return to OpenROV to repair.

[* black] Do a wiggle test ofon the motor to make sure it is securely mounted.
[* black] Do this step for both horizontal motors.