Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #21

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[title] Install horizontal motor mount screws
[* black] Screw in two M3 10mm motor mount screws.
[* icon_caution] '''Do not over-tighten screws'''. Turn screws until they begin to become tight. Then give an additional quarter turn (90º). Do not over-tighten.
[* icon_caution] '''Do not over-tighten screws'''. Turn screws until they begin to become tight. Then give an additional quarter turn (90º). Do not over-tighten.
[* black] Grasp the motor shaft and test the connection of the mount by attempting to wiggle the motor. There should be no motion of the motor when you do this.
[* icon_note] The previous step shall henceforth be referred to as "the wiggle test!"
[* black] Do this for both horizontal motors.