Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #21

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[*title] Install horizontal motor mount screws
[*
black] Screw in the two M3 10mm motor mount screws (better detail)screws.
[* icon_caution] Turn screws until they becomebegin to become tight. Then give an additional quarter turn (90º). Do not over-tighten.
[* black] NEED PICSGrasp the motor shaft and test the connection of the mount by attempting to wiggle the motor. There should be no motion of the motor when you do this.
[* icon_note] The previous step shall henceforth be referred to as "the wiggle test!"
[* black] Do this for both horizontal motors.
[*title] Install horizontal motor mount screws
[*
black] Screw in the two M3 10mm motor mount screws (better detail)screws.
[* icon_caution] Turn screws until they becomebegin to become tight. Then give an additional quarter turn (90º). Do not over-tighten.
[* black] NEED PICSGrasp the motor shaft and test the connection of the mount by attempting to wiggle the motor. There should be no motion of the motor when you do this.
[* icon_note] The previous step shall henceforth be referred to as "the wiggle test!"
[* black] Do this for both horizontal motors.

Image 1

No previous image

Added

Image 2

No previous image

Added