Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] If your motors don't already havetitle] Attach propellers on them now is the time to attach them.rear motors
[* black] Place a full coverage but not dripping amountdrop of the provided threadlocker or locktite onto the top 6mm ofinto the threaded rod on each end ofhole in the motor shaftspropeller.
[* black] TightenPlace the propellerspropeller onto the motor shaft. Ensure the propeller is threaded straight on the shaft and tighten fully.
[* icon_note] It helps to use your fingers around the silver motor bell and/or motor shaft to steady the motor while you tighten the propeller.
[* icon_caution] Please ensure the correct propeller is installed. Refer back to step 12 for the correct orientation. Trident will not function correctly without.
[* black] If your motors don't already havetitle] Attach propellers on them now is the time to attach them.rear motors
[* black] Place a full coverage but not dripping amountdrop of the provided threadlocker or locktite onto the top 6mm ofinto the threaded rod on each end ofhole in the motor shaftspropeller.
[* black] TightenPlace the propellerspropeller onto the motor shaft. Ensure the propeller is threaded straight on the shaft and tighten fully.
[* icon_note] It helps to use your fingers around the silver motor bell and/or motor shaft to steady the motor while you tighten the propeller.
[* icon_caution] Please ensure the correct propeller is installed. Refer back to step 12 for the correct orientation. Trident will not function correctly without.