Skip to main content

Site Navigation

Your Account

Choose Language

Changes to this Step

Edit by OpenROV (Sofar)

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Plug in the motor plugs and screw the two M2 screws on either side. Tighten them "monkey tight"
[* black] Turn screws until they become tight. Then give an additional quarter turn (90º). Do
not "gorilla tight."over-tighten. Make sure both screws are applying even pressure to the gasket.
[* black] NEW PIC Do this for both the left and right motors.
[* black] Plug in the motor plugs and screw the two M2 screws on either side. Tighten them "monkey tight"
[* black] Turn screws until they become tight. Then give an additional quarter turn (90º). Do
not "gorilla tight."over-tighten. Make sure both screws are applying even pressure to the gasket.
[* black] NEW PIC Do this for both the left and right motors.