Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #14

Edit by Eric Stackpole

Edit approved by Eric Stackpole

Before
After
Unchanged

Step Lines

[* black] Remove plastic backing from a 90mm endcap disk (the small one)
[* black] Place a syringe piece through its center hole so that the disk is close to the small-hole-side of the syringe. (It’s supposed to be a very tight fit.)
[* black] Remove backing from a 94mm endcap disk and push the small-hole-side of the syringe into it’s center hole
[* black] Make sure that the small-hole-side end of the syringe is flush with the outside face of the 94mm endcap disk
[* black] Align the wire harness holes of the two disks
[* black] You can also find a video showing how to do these steps here: http://youtu.be/XCI5pkl50Vo