Changes to Step #14
Edit by OpenROV (Sofar) —
Edit approved by OpenROV (Sofar)
- Before
- After
- Unchanged
Step Lines
| [* black] Remove plastic backing from a 90mm endcap disk (the small one) |
| [* black] Place a syringe piece through its center hole so that the disk is close to the small-hole-side of the syringe. (It’s supposed to be a very tight fit.) |
| [* black] Remove backing from a 94mm endcap disk and push the small-hole-side of the syringe into it’s center hole |
| [* black] Make sure that the small-hole-side end of the syringe is flush with the outside face of the 94mm endcap disk |
| [* black] Make sure that the small-hole-side end of the syringe is flush with the outside face of the 94mm endcap disk |
| [* black] Align the wire harness holes of the two disks |