Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #79

Edit by RogerB

Edit approved by OpenROV (Sofar)


Step Lines

[* black] Solder the two sets of wires to each pin on the terminal block.
[* black] Use hot glue (or better yet super glue) to secure the terminal block to the back of the case. The terminal block should fit flush against the back panel of the homeplug adapter.
[* black] The USB REG fits into the case so that the USB connector fits into the hole cut out for it on the same panel as the RJ45
[* black] After the hot glue has hardened, you can attach the tether from the ROV to the terminal block on the homeplug adapter.
[* icon_note] Because of the way the Homeplug communication protocol works it does not matter which wire goes into either terminal. Just plug the wires in in any orientation and it should work!