OpenROV
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #78

Edit by OpenROV (Sofar) —

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereSolder wires onto the remaining three pins (one close to the Ethernet jack on the 3-pin header, and two on a separate header toward the back of the board)
[* black] Solder the two leads from the 2-pin header respectively to the "+5v" line coming from the USB REG and the left over pin (GND) on the 3-pin header. It does not matter which wire from the 2-pin header attaches to the 5v supply or the ground.
[* black] Pull the two sets of joined wires through the each hole on the back of the topside adapter using pliers.
[* black] Insert wisdom hereSolder wires onto the remaining three pins (one close to the Ethernet jack on the 3-pin header, and two on a separate header toward the back of the board)
[* black] Solder the two leads from the 2-pin header respectively to the "+5v" line coming from the USB REG and the left over pin (GND) on the 3-pin header. It does not matter which wire from the 2-pin header attaches to the 5v supply or the ground.
[* black] Pull the two sets of joined wires through the each hole on the back of the topside adapter using pliers.