OpenROV
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #77

Edit by OpenROV (Sofar) —

Edit approved by OpenROV (Sofar)

Before
After
Unchanged

Step Lines

[* black] Insert wisdom hereSolder three ~10cm lengths of 20awg wire into the three holes on the USB REG board. The stripped wires make a tight fit into the holes, so you may need to remove a few strands from each.
[* black] Use a flush cutter to trim off excess wire.
[* black] After adding shrink tubing, solder the "+3.3V" and "GND" wires coming from the USB Reg to the middle and outer pins in the three-pin header on the homeplug adapter respectively. (Wiring diagram on next page).
[* black] Insert wisdom hereSolder three ~10cm lengths of 20awg wire into the three holes on the USB REG board. The stripped wires make a tight fit into the holes, so you may need to remove a few strands from each.
[* black] Use a flush cutter to trim off excess wire.
[* black] After adding shrink tubing, solder the "+3.3V" and "GND" wires coming from the USB Reg to the middle and outer pins in the three-pin header on the homeplug adapter respectively. (Wiring diagram on next page).